Cool VL Viewer forum

Hello, Henri,

When i modify the Preference/Graphics/Quality and performance with the cursor "Low-Mid-Hight-Ultra", I realise now that this decrease the RenderVolumeLODFactor from 1.125 to 2.000 (max)
But RenderVolumeLODFactor must always be on 4.000 minimum to see perfectly the curve of the prims .... I must then change his value with the "Debug Settings".
It's not possible that the RenderVolumeLODFactor stay always on 4.000 or if not, creating a fast shortcut to do faster an easier the change ? ...

TiA...

u can do this myrr


Path:

cool vl/skins/default/xui/en-us/panel_preferences_graphics1.xml



Then edit the LOD here just below mesh detail .. I renamed it as i wanted and put the value i like and shifted a few points to make it all fit in the panel - obviously u can edit it as u like .. I enabled the text also so i can see exact .. and this will save u having to go to the debug, hope this helps u.


<slider bottom_delta="-22" can_edit_text="true" control_name="RenderVolumeLODFactor"
decimal_digits="3" enabled="true" follows="left|top" height="16"
increment="0.250" initial_val="160" label=" RenderVolume:"
label_width="90" left_delta="0" max_val="6" min_val="0"
mouse_opaque="true" name="ObjectMeshDetail" show_text="true" width="223" />

Thanks Alexia .

But i cannot save the modifed file because I have an "Acces denied".
I have administrator Rights and Cool VL is not open.

That’s unfortunate Myrr .. but this isn’t a viewer issue, perhaps visit a PC forum for whatever system you use to learn how to access your directory and edit this file. Good luck!