Cool VL Viewer forum

Is there some debug setting or something to configure how much the up/down arrows in the edit prim box for Slice Begin and End go up/down by? It's driving me insane that there's no way to get them to stop at 0.25 or 0.75 (my two most frequently used settings after 0.5), it skips right past, going from 0.24 to 0.26...

I could have sworn you used to be able to set those without manually entering the value. Didn't they used to go up/down by 0.05? Going up by 0.025 would still allow them to hit 0.25 and 0.75 without being quite that fast.

Hm, isn't it easier to just type in the values (4 keystrokes each) instead of scrolling through the numbers my many clicks?

agree, its easier and faster to enter it by hand